Week 26  This week we get the second part of the rear superstructure

The bits we received

And what we did with them

I've glued the round cover, tow bracket and light on the outside of the rear part.  These were just done with super glue.

The tow hook will be fitted after any camouflage has been applied.  The starter cover needs to be painted on the back, so this will be fitted after it's painted.  Note that the smaller pin of the starter cover is too long and needs about 1/2 its length cutting off.

The bracket is fitted on the inside.  The inside will be painted red oxide rather than ivory.

The interior is painted red oxide.

The hand crank plate was given a couple of coats of paint, as was the exterior of the bulkhead.  Then the hand crank plate was attached.  It will get another couple of coats of paint now everything is glued in place.

The tow hook will not be fitted until after the exterior painting and any camo pattern is completed.

Things not yet done

Issue 9 : Assemble the turret.
Issue 10 : Finish the emergency exit.
Issue 11 : Paint and fit spare track links.
Issue 19 : Fit ball and headlight
Issue 22 : Finish the engine cover
Issue 23 : Paint the radiator covers
Issue 24 : Finish the issue
Issue 25 : Paint and fit the track cable.
Issue 26 : Tow hook to paint and fit.

Take me back to week 25

Take me to week 27