Week 127 This week we get the first ammo box
The bits we received
And what we did with them
As usual I've started with some assembly. Make sure the first two sides are square. I used a glue pot, but Lego or any other square object would do.
The next two middle part also need to be square.
Now the side can go on.
I then put the rack in place while the glue dried to make sure it set straight.
Then the rack is painted ivory.
The shells are painted now, so I can continue.
The shells are all inserted into the case. If you shells are a little 'variable' you can put the good ones on the outside, and the less than perfect ones go towards the bottom and on the inside where they won't been seen. All my shells are perfect of course, even the ones you can't see ;o)
Glue the end of the case in place.
And finally glue the shell case in place.
Things not yet done
Issue 25 : Complete issue
Issue 32 : Complete the tow cable
Issue 33 : Complete issue
Issue 41 : Fit fire extinguisher
Issues 54 to 65 : Fit the hub caps
Issue 106 : Containers to add
Issue 107 : Paint the ammo boxes
Issue 109 : Paint the parts
Issue 113 : Complete the issue
Issue 115 : Paint and assemble the parts
Issue 116 : Paint the radiator
Issue 118 : Paint and assemble the fans
Issue 119 : Paint the radiator
Issue 121 : Paint the fuel tank
Issue 122 : Paint the fuel tank
Issue 124 : Paint the shells
Issue 125 : Paint the shells
Issue 127 : Finish the issue